all this took me probably around 10 hours to accomplish. The enclosure with the motor can be lifted off with another set of 4 screws, but you have to be very precise when you put it back together. If you attempt to do a cleaning routine like this yourself, be careful. The Pakon is pretty easy to open, it has 4 screws beneath and you can lift the top off. However, this one is very soft, so most likley it is something between the film and the sensor, on the other side of the focusing lens. A very “in focus” banding issue is not good, because that probably means you have hot or dead pixels in your CCD sensor, and that can not be fixed. The softer the edges, the more “out of focus” the issue is. If you look at it carefully, you can see that the line does not have hard edges. You can either have convenient and deal with issues like this, or have something super complicated to setup to get rid of possible dust/banding/quality issues. All scanners are pretty bad, no matter what you do. Well, I’ve seen this type of issues before. At second glance, every frame has a dark stripe going through it. Then I tried to scan a roll of BW, at first glance, not bad. Scanned a roll of C41 and boy is it fast.
#Pakon f135 scanner software#
I tried with VMWare instead and now everything worked perfectly from the software side of things. USB problem, cable problem, virtual machine problem, it could be any number of things.įor some reason, a lot of people have had good success with Virtualbox, but I did not. After much digging around, it seems it is a problem with the data stream, which means that something is getting a hiccup when transferring bits from the scanner to the virtual machine. Googling gave me very little results, something about sync being lost. I kept getting an error that just said 1003. Of course I don’t have an XP machine just lying around, so I went with the virtual machine route.
#Pakon f135 scanner windows#
But it is old, difficult to find in good condition, and needs Windows XP to run. It is fast like nothing else, at least if you’re compared to slow consumer scanners. The thing that makes it really nice is SPEED. It came out in the early 2000s as a minilab scanner. It is a famous scanner for people like me, so you probably know this scanner too. So then I decided to try the Pakon route instead. Scammers tried to scam me instead of send me a scanner. At first I tried getting a Nikon Coolscan 5000 but failed 2 times on ebay. The Plustek is such a pain in the ass since it doesn’t do any type of batch scanning. For a while I have been searching for a scanner that has a better workflow than the Plustek 8200.